Description of MZ45 Cam Clutch Backstop
1. MZ Series Cam Clutch is Shielded by shield bearings on both ends, packed with a special grease, and are ready for use. No additional lubricant is required.
2. For attaching pulleys, gears or sprockets to the clutches, insert hubs (with f7 tolerance of ISOR773) along the inner surface of the outer race and screw the bolts (high tension) into the tapped holes on the clutch end.
3. Recommended shaft tolerances are shown in the table on the lower left.
4. External thrust load should be supported by other devices, not by the Cam Clutch.
5. Use only a parallel key to secure the clutch to the shaft. Do not use a tapered Key.
6. When mounting the clutch onto the shaft, apply pressure to the inner race but never to the outer race.
Data sheet of MZ45 Cam Clutch Backstop
Model |
MZ45 | |
Torque (Nm) | 1620 | |
Overrunning Speed (r/min) | Inner race | 1400 |
Outer race | 300 | |
Bore Size (mm) | 45 | |
Outer Race Size (mm) | 125 | |
Thickness (mm) | 92 | |
Weight (Kg) | 6.2 |
Related Product Tags:
air bearing , auto air conditioner bearing , air conditioner bearing , air conditioner bearings , alternator bearing , alternator bearing ford , alternator bearings , axle bearing , rear axle bearing , ball bearing ring , ball bearing units , ball bearings , automobile ball bearings , ceramic ball bearing , Screw Ball Bearing , contact ball bearing , loose ball bearing , loose ball bearings