OEM Number:9627773180 Terminals:15pins with green ring Can control the temperature from 75----90 degrees , to keep the water in a stable temperature , let your cars start easily
Tradicionally, Magnetic Sensors´ performance has been challenged by components´ tolerances, thermal and magnetic fluctuactions which needed complex designs and circuitry to solve fluctuations in output signals. This could discourage OEMs from designing in these sensors. The Programmable Hall Effect technology used by Piher is only sensitive to the flux density coplanar with the IC surface thus eliminating all those problems and enabling low-cost contactless sensors to be manufactured for extreme enviroments including the automotive and industrial markets. Limitations of potentiometric solutions such as wear and limited electrical angle are overcome by this compact design, robust sensor which enjoys virtually endless mechanical life (maintenance free) and up to 360º electrical angle (without dead band). The angular information output is selectable between Analog (12-bit), programmable pulse width modulation (12-bits) and Serial Protocol (14-bits signal + diagnostic). Furthermore full redundancy can be achieved by employing a dual core version or the simple placement of two sensors within the housing. The fact that a configurable switch ouptput is integrated within each sensor and positive slopes & one negative slope can be programmed in the same transfer characteristic are never-seen-before features in conventional Hall Effect Sensors. Typical applications for Piher contactless sensors are: • Non-Contacting long life angle/position sensor • Absolute Rotary Position Sensor • Industrial Joysticks • Marine sensors & controls • Brake Position Sensor • Throttle/EGR Valve and Gear Position Sensor • Height & suspension Sensor • Non-Contacting Potentiometer • Float-Level Sensor • Motor-shaft Position Sensor • Precision Robotics, industrial equipment and HVAC monitoring & control...
Hall Effect Gear Tooth Sensor uses a magnetically biased Hall Effect integrated circuit to accurately sense movement of ferrous metal targets. This specially designed integrated circuit, with bias magnet and discrete capacitor, is sealed in plastic or metal package for physical protection and cost effective installation. Features ? Sensing ferrous metal targets ? Digital current sinking output (open collector) ? Good signal-to-noise ratio ? Excellent low speed performance ? Output amplitude not dependent on RPM ? Fast operating speed, over 100kHz ? EMI resistant ? Reverse polarity protection and transient protection ? Wide operating temperature -40°C ~ +135°C.